Based on this requirement, we will program the SmartOne C to set the Change of Location Area (size of the depots where the trailers will visit), the message interval while the trailers are inside the Change of Location Area (1 per day), the interval at which the SmartOne will check its location while in a State of Vibration and inside the Change of Location Area(1 per hour), set the number of messages when the trailer leaves the Change of Location Area (1 Change of Location Area Alert Message) and the message interval while the trailers are in transit between depots (every 3 hours).īy comparing current and prior position information, the SmartOne determines if its location is changing. Lastly, they want a location message every 3 hours when a trailer is moving between depots.
They also want a message notification within 1 hour when a trailer has left a depot. When the trailer(s) are sitting at a depot they want a location message once a day. Usage Example: A fleet operator owns 1,000 trailers. These message intervals are set as part of the configuration process based on the concept that repeated reporting information of the same location, when an asset has not moved from its defined area, is redundant and doesn’t provide additional usable information about its current location. Reduced Messaging Mode extends the battery life associated with transmitting messages over Globalstar’s satellite network by sending messages at a minimal message interval when the asset is in a defined area and transmits at a higher message interval when the asset is changing locations. Based on this requirement the Company has 2 options: set a message interval of every 12 hours, the 12-hour interval begins when the device is powered up or when the configure message times of day are 12:00 noon and 12:00 midnight. Usage Example: A Company is required to report the GPS locations of their hazardous chemical containers twice a day.
If the SmartOne went In Motion it would transmit its location message every hour. The SmartOne would transmit 3 messages a day at the same configured times every day. If the SmartOne went into motion at any time of day the Message Interval while In Motion would be every 2 hours beginning when the SmartOne started moving.Įxample of Message-Time(s) of Day: The SmartOne is configured with a message time of day of 9:00 am, a second message time of day of 12:00 noon, a third message time of day of 8:00 pm and once per hour when In Motion. In standard message mode, we can configure the SmartOne's internal motion sensor to transmit its position at independently configured regular time intervals when the device is in motion.Įxample of Message Interval: The SmartOne is configured to report once every 24 hours when not In Motion and every 2 hours when In Motion. In this mode, the SmartOne reports its positions at regular time intervals that are programmed to your specification. The SmartOne C can either be line-powered or run off of internal battery (4 AAA 1.5V lithium batteries), removing the need to purchase expensive proprietary batteries for replacement. SmartOne C Satellite Managed Asset Ready Trackerĭesigned for management of powered and non-powered fixed and mobile assets, the SmartOne C is easy to deploy practical solution for tracking asset location anywhere in the world.
0 kommentar(er)
